Microprocessor:

• One Intel® Xeon™ 2.00 GHz dual-core
• 1333 MHz front-side bus (FSB)
• 2 MB Level-2 cache

Memory:

• Two 512 MB (1 GB total memory)
• Type: PC2-5300 ECC DDR fully-buffered SDRAM
• Connectors: one dual inline memory module (DIMM)

Drives:

• Hard disk drive: One 80 GB Serial ATA (SATA)
• External USB diskette drive (optional)
• One CD-RW/DVD-RAM Multiburner

Expansion bays:

• 3.5-inch simple-swap drive bay configuration support up to two 3.5-inch simple-swap SATA hard disk drives

PCI Expansion slots:

• One PCI Express x8 (half length, full height)
• One converted PCI-x with 133 MHz riser

Power supply:

• One 670-watt

How-swap fans:

• Standard: five

Size:

• Height: 43 mm (1.67 inches)
• Depth: 711 mm (28.0 inches)
• Width: 440 mm (17.3 inches)
• Maximum weight: 15.6 kg (34.5 lb)

Integrated functions:

• Four Universal Serial Bus (USB) 2.0 ports (two front and two rear)
• One serial port
• Two integrated dual 10/100/1000 Mbps Ethernet ports
• External modem

Hard disk controllers:

• Serial ATA (SATA) controller

Acoustical noise emissions:

• Sound power, idling: 6.3 bels

Environment:

• Air temperature:
  • Server on: 10° to 35°C (50.0° to 95.0°F)
  • Server off: 10° to 43°C (50° to 109.4°F)
• Altitude: 2133 m (7000 ft)
• Humidity (on and off): 8% to 80%

Heat output:

Approximate heat output in British thermal units (Btu) per hour:

• Minimum configuration: 648 Btu per hour (190 watts)
• Maximum configuration: 1706 Btu per hour (500 watts)

Electrical input:

• Sine-wave input (47-63 Hz) required
• Input voltage low range:
  • Minimum: 100 V AC
  • Maximum: 127 V AC
• Input voltage high range:
  • Minimum: 200 V AC
  • Maximum: 240 V AC
• Input kilovolt-amperes (kVA), approximately:
  • 0.50 kVA

Video controller (integrated):

• ATI Radeon RN50/ES1000 (dual ports - front and rear)

Notes:

1. Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use.
2. These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in acordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate.