|
Removing
the simple-swap backplate
To remove the
simple-swap backplate:
- Turn off
the HMC and peripheral devices and disconnect all power cords.
- Unlock and
remove the side cover. (Refer to Removing
and Replacing the Cover.)
- Remove the
lower bezel. (Refer to Removing
and Replacing the Lower Bezel.)
- Remove the
simple-swap hard
disk drives. (Refer to Removing
and Replacing a Simple-swap Hard Disk Drive.)
- Remove the
front fan assembly from the hard disk drive cage. (Refer to Removing
and Replacing the Front System Fan Assembly.)
- Disconnect
the power cables from the simple-swap backplate.
- Disconnect
the signal cables from the system board.
- Press and
hold the drive cage release tab. Then, rotate the drive cage out
of the chassis until the retaining tab on top of the cage locks
into place.
- Press up
on the retaining latch at the top of the drive cage. Then, tilt
the top of the simple-swap backplate away from the drive cage
until it is clear of the locating pins.
- Lift the
simple-swap backplate out of the lower lip on the drive cage.
- If you are
instructed to return the simple-swap backplate, follow all packaging
instructions, and use any packaging materials supplied to you
for shipping.
|